HOME |
Ultrasonic Barcode Reader |
||||||||||||||||||||||
HX19RBC-USRF-USB-8-IP67 The
low power hx19 battery barcode receiver; polls periodically for hx19tbc
barcode transmitters, it is also alert to receive asynchronous barcode.
The barcode result is made available through a micro USB port. Output form
is standard barcode signal through I/O port pins, and/or SPI, I2C, RS232,
Ethernet (interface).
|
||||||||||||||||||||||
HX19RBC can be purchased with or without ultrasonic
barcode, or as only radio frequency barcode. |
35 x 35 x 15 mm, ABS plastic enclosure. Sonic surface: Zinc Plated Steel. IP67 watertight |
|||||||||||||||||||||
|
|
Low cost ultrasonic RF barcode systemThe ultrasonic barcode system shown below, allows the user to enter his own barcode into the permanent flash memory of T1. Hexamite offers devices using RF barcode, Ultrasonic barcode or both. The device can be configured permanently to emit barcode upon detection of RF stimuli, emit periodically or both. The system can operate using wires, on the Ethernet, through private network or wireless network. All devices are low power and can operate from batteries for years. The advantage of ultrasonic RF combination is the ability to contain and better localize the barcode signal. Often RF barcode will suffice, but in case an automobile is driven from a group into a shipping container, it is easier for the container to log which item was loaded. See the example below. You can mail a request for a preliminary user manual, and further technical details to: |
>> |
Copyright © 1999 [Hexamite]. All rights reserved. Revised: December 16, 2016 . |
<< |