FEATURES
-
Range up to 35 meters
-
Typical Precision 1mm
-
Super Speeds up to 64 readings/second
-
Multi-layered Ultrasound 25 and 40khz
-
Small Size
-
One device does all, transmitter, receiver and 3D
system driver and master.
DESCRIPTION HX19TR
Hx19tr is a very high speed, high precision ultrasonic positioning
system, with a significantly improved range up to 35 meters and 5mm precision
(25khz sensor). Maximum sampling
rate is 64 samples/second and the system can be multi-layer, frequency
separation multiplies the positioning frame rate. Using 2 frequency
layers 25khz and 40khz enables a total acquisition of 128 (xyz) coordinate
points per second. The device on the right is a hx19tr40khz-USB it has an
internal FDTI USB controller, drivers are available for many operating systems.
|
|
Size: 97 x 40 x 15 mm or 3.82" x 1.57" x
0.6" with ears |
The hx19tr is designed to serve many positioning needs, and serves equally
well for guidance and tracking. Each hx19tr is a transponder, useful as both a
transmitter and a receiver. It also times its own echo, adding anti-collision
features to the system; while providing the distance from itself to any other
active members of the hx19 family. |
The HX19TR Serial Wire
The hx19tr comes
with a four conductor pigtail lead, red, blue, green and black. Red and
Green are the power wires, where Green is the reference (ground), and
the red provides the supply voltage ranging from 4V to 16Vdc. Yellow and
Orange are used as communication signal carriers. All hx19tr types
have a wire interface, or may be terminated with a USB plug for
computers. Some hx19tr devices will have additional RF wireless
interface. The wireless units synchronize communities of hx19tr devices,
and provide data-link between networks as well as individual devices.
What is received by wireless communication is repeated on the wire, and
what comes over the wire is repeated by RF wireless broadcast. The same
applies to the USB version.
Size: 80 x 40 x 15 mm or 3.15" x 1.57" x 0.6"
without ears
Size: 97 x 40 x 15 mm or 3.82" x 1.57" x 0.6"
with ears
|
|
Difference between the hx19tr and other hx19
members.
The hx19tr, is server to wireless network or wired
network. It repeats incoming data on the wire through wireless broadcast
and vice versa. Operation is simplex, i.e. the device must wait for
transmission to finish before sending a reply. It simplifies wiring by
allowing communication through a single wire, and a ground return, or
long-range rs485 communications. It is self-sufficient needs no support
and has echo mode embedded into its positioning cycle.
|
For more information email request to:
service@hexamite.com
|